The advantage of an electric window regulator is substantial in comparison with manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. Also, it is not always easy to identify precisely the source of the failure. Here we will find out how to replace the electric window regulator of a Toyota Rav 4 (4th Generation) . But before seeing the procedure to follow, you must be sure to understand where the dysfunction comes from. Let's be clear, it is sometimes unnecessary to replace the entire window regulator, a simple small repair will sometimes work. Whether it's an electrical short circuit, or just a lack of oil. Now that you are sure of the source of the problem, let's get to the heart of the matter.window-changer-Toyota-Rav-4- (4th-Generation)

Replacing a window regulator in Toyota Rav 4 (4th Generation): how to do it

Changing a window regulator is quite long. Depending on your expertise in the field, count approximately two o'clock to make sure you have the time you need. Whether on a Toyota Rav 4 (4th Generation) or on another vehicle, this repair is for experienced DIY enthusiasts. So let's look at how to do it, step by step. It is advisable to take photos at different times to help you install the new window regulator.

Removing a window regulator on a Toyota Rav 4 (4th Generation)

  • Remove all of the door trim. From the mirror cover to the handle. This should be done very gently with a flat screwdriver. You will have to make sure you have access to the window regulator at any point without being disturbed. This step is quite long to perform.
  • Remove the window regulator seals from your Toyota Rav 4 (4th Generation). Again, it is essential to do this with care.
  • Now that you have accessed the window regulator, disconnect the connectors. You can then remove the motor from the window regulator if it is stuck.
  • Release all the fasteners that hold the window, then release it. It is sometimes advisable to place the window halfway up to be able to carry out this manipulation. Of course we will have to be extremely careful when handling the glass. It is best to put it on a rather thick sheet.
  • Remove the window regulator completely. It is essential to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held by screws or rivets, it will therefore be necessary to remove them.

The installation of an electric window regulator of a Toyota Rav 4 (4th Generation)

  • Fit the new window regulator. Make sure that its location is similar to the damaged window lifter. You will probably have to use the clips you removed.
  • Replace the glass as you removed it. It will sometimes be necessary to move it a little so that it fits properly in its guide.
  • Reconnect the connectors.
  • Fit the seals you removed.
  • Replace all of the door trim.

It's good, you now have a new and working window regulator . You can therefore turn on your car and test it.