The advantage of an electric window regulator is enormous in comparison with manual mechanisms. However, it has the disadvantage of being much more restrictive in terms of repairs. Also, it is not necessarily easy to identify precisely the nature of the problem. In this article we will see how to repair the electric window regulator of a Toyota Uuv . But before seeing the procedure to follow, you must be certain of knowing where the dysfunction comes from. Let's be clear, it is sometimes unnecessary to change the entire window regulator, a simple small repair can often suffice. Whether it concerns an electrical short circuit, or just a lack of lubrication. Now that you are sure of the source of the problem, let us return to our subject.change-window-regulator-Toyota-Uuv

Replacing a Toyota Uuv window regulator: how to do it

Replacing a window regulator is quite time consuming. Depending on your experience on the subject, plan approximately two o'clock to make sure you have the time you need. Whether it is on a Toyota Uuv or on another vehicle, this manipulation is for experienced DIY enthusiasts. So let's see what to do, step by step. We advise you to take photos at several stages in order to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Uuv

  • Remove the entire door trim. From the handle to the mirror cover. This should be done with enough caution using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This manipulation is the longest to execute.
  • Remove the window regulator seals from your Toyota Uuv. Again, it is essential to take it delicately.
  • Now that you have accessed the window regulator, remove the connectors. You must then remove the motor from the window regulator in case it is stuck.
  • Release all the fasteners that hold the glass, then take it out. It is sometimes better to place the window halfway up to be able to carry out this operation. Of course you will have to be very careful when moving the glass. It is advisable to place it on a sufficiently thick sheet.
  • Remove the window regulator entirely. It is essential to remember its location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held by screws or rivets, it will therefore be necessary to remove them.

The installation of an electric window regulator of a Toyota Uuv

  • Fit the new window regulator. Make sure that its position is similar to the previous window lifter. You will certainly have to use the fasteners that you removed.
  • Reposition the glass in the same way as you removed it. It will sometimes be necessary to rotate it a little so that it fits correctly in its guide.
  • Connect the connectors.
  • Replace the seals you removed.
  • Replace the door trim assembly.

It's done, you now have a new and functional window regulator . You must therefore switch on the ignition and test it.