The interest of an electric window regulator is enormous in comparison with manual mechanisms. However, it has the drawback of being much more complex in terms of repairs. Moreover, it is not necessarily easy to identify precisely the nature of the problem. In this article we will see how to change the electric window of a Toyota Verso-s . But before seeing what to do next, you have to be sure you know where the failure came from. Indeed, it is sometimes unnecessary to change the entire window regulator, a simple small repair will sometimes work. Whether it concerns an electrical short circuit, or simply a lack of oiling. Now that you've identified the source of the concern, let's get back to our topic.change-window-Toyota-Verso-s

Toyota Verso-s window regulator replacement: how to do it

Changing a window regulator is rather time-consuming. Depending on your expertise on the subject, count approximately three hours to make sure you have the necessary time. Whether for a Toyota Verso-s or on another car, this manipulation is for experienced DIY enthusiasts. So let's take a look at what to do, step by step. We recommend that you take a picture in several steps to help you fit the new window regulator.

Removing a window regulator on a Toyota Verso-s

  • Disassemble the entire door trim. From the handle to the retro cover. This operation should be done rather gently using a flat screwdriver. Make sure to access the window regulator at all points without being disturbed. This step is the longest to perform.
  • Remove the window regulator seals from your Toyota Verso-s. Once again, it is essential to go about it with care.
  • Now that you have accessed the window regulator, disconnect the connectors. You will then have to remove the motor from the window regulator if it is ever stuck.
  • Take out all the fasteners that hold the glass in place, then remove the glass. It is sometimes more judicious to position the window halfway up to perform this operation. Of course, you have to be very careful when moving the window. It is better to put it on a rather thick sheet.
  • Completely disassemble the window regulator. It is essential to memorize your position well. You can take a picture of it if it helps you fit the new window regulator. The window regulator is sometimes held by screws or rivets, so they will have to be removed.

The installation of an electric window of a Toyota Verso-s

  • Present the new window regulator. Make sure that its position is similar to the damaged window regulator. You will probably need to use the fasteners you removed.
  • Replace the glass the same way you took it out. It will sometimes be necessary to move it slightly so that it fits properly in its guide.
  • Reconnect the connectors.
  • Replace the seals that you have carefully removed.
  • Refit all of the door trim.

It's done, you now have a new and functional window regulator . You will therefore have to switch on and test it.