The advantage of an electric window regulator is undeniable in comparison with manual window regulators. On the other hand, it has the defect of being much more complicated in terms of repairs. In addition, it is not always easy to pinpoint the cause of the problem. In this article, we will see how to change the electric window regulator of a Toyota Yaris 2 . But before you start, make sure you know where the fault is coming from. Indeed, it is sometimes unnecessary to replace the entire window regulator, a simple small repair can often work. Whether it's an electrical short circuit, or simply a lack of lubrication. Now that you are sure of the source of the malfunction, let's get back to our topic.
How to replace a Toyota Yaris 2 window regulator
Replacing a window regulator is rather tedious. Depending on your expertise on the subject, plan approximately three hours to make sure you have the time you need. Whether on a Toyota Yaris 2 or another car, this manipulation is for experienced DIY enthusiasts. So let's look at how to do it, step by step. We advise you to take photos at different times to help you reassemble the new window regulator.
Removing a window regulator on a Toyota Yaris 2
- Remove the entire door trim. From the handle to the mirror cover. This should be done very gently using a flat screwdriver. It will be necessary to ensure access to the window regulator at any point without being obstructed. This step is quite long to perform.
- Disassemble the window regulator seals from your Toyota Yaris 2. Again, it's wiser to do so with care.
- Now that you have accessed the window regulator, remove the connectors. You will then have to disengage the window regulator motor when it is blocked.
- Release all the fasteners that hold the glass, then remove it. It is sometimes advisable to position the window halfway up to perform this operation. Of course you have to be very careful when handling the glass. It is best to place it on a sufficiently thick sheet.
- Disassemble the window regulator completely. It is wiser to memorize your location. You can take a picture of it if it helps you to install the new window regulator. The window regulator is sometimes held in place by screws or rivets, it is therefore necessary to remove them.
The installation of an electric window regulator of a Toyota Yaris 2
- Present the new window regulator. Make sure that its location is identical to the damaged window regulator. You probably need to use the fasteners you have set aside.
- Reposition the glass as you removed it. It will sometimes be necessary to rotate it a little so that it fits correctly in its guide.
- Connect the connectors.
- Fit the seals that you have carefully removed.
- Replace the entire door trim.
It's done, you now have a new and functional window regulator . You will therefore have to turn on your car and test it.