The advantage of an electric window regulator is undeniable compared to manual window regulators. However, it has the disadvantage of being much more complex in terms of repairs. In addition, it is not always easy to identify precisely the source of the failure. In this article, we will discover how to change the electric window regulator of a Toyota Yaris Ts . But before seeing the procedure to follow, you must be sure to know where the dysfunction came from. Indeed, it is sometimes unnecessary to replace the entire window regulator, a simple repair will often suffice. Whether it concerns a false contact, or simply a lack of oiling. Now that you are sure of the source of the problem, let's get to the heart of the matter.change-window-regulator-Toyota-Yaris-Ts

How to replace a Toyota Yaris Ts window regulator

Replacing a window regulator is relatively time-consuming. Depending on your experience on the subject, count approximately three hours to make sure you have the time you need. Whether it's for a Toyota Yaris Ts or another car, this repair is for experienced DIY enthusiasts. So let's see how to do it, step by step. We advise you to take pictures at several stages to help you reassemble the new window regulator.

Removing a window regulator on a Toyota Yaris Ts

  • Remove all of the door trim. From the mirror cover to the handle. This should be done relatively carefully with a flat screwdriver. You will have to make sure you have access to the window regulator at all points without being embarrassed. This manipulation is the longest to perform.
  • Remove the window regulator seals from your Toyota Yaris Ts. Again, it is essential to take it delicately.
  • Now that you have accessed the window regulator, disconnect the connectors. You must then release the window lifter motor in the event that the window is blocked.
  • Release all the fasteners that hold the glass, then take it out. It is sometimes better to position the window halfway up to be able to carry out this operation. Of course you will have to be very careful when handling the glass. It is advisable to place it on a sufficiently thick sheet.
  • Remove the window regulator as a whole. It is essential to remember your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is at times held in place by screws or rivets, so you must remove them.

The installation of an electric window regulator of a Toyota Yaris Ts

  • Present the new window regulator. Make sure that its position is similar to the damaged window lifter. You will probably have to use the fixings that you removed.
  • Replace the glass in the same way as you removed it. At times it will be necessary to rotate it slightly so that it fits properly in its guide.
  • Connect the connectors.
  • Fit the seals that you have carefully removed.
  • Replace all of the door trim.

It's done, you now have a new and working window regulator . So you need to turn on your car and test it.