The advantage of an electric window regulator is substantial in comparison with manual mechanisms. However, it has the defect of being much more restrictive in terms of repairs. In addition, it is not always easy to pinpoint the source of the problem. In this article we will see how to replace the electric window regulator on a Volkswagen Golf 7 Sw Alltrack . But before you start, you need to be sure you know where the malfunction came from. Let's be clear, it is from time to time unnecessary to change the entire window regulator, a simple repair will sometimes be enough. Whether it's an electrical short, or just a lack of lubrication. Now that you've identified the source of the concern, let's get to the heart of the matter.change-window-regulator-Volkswagen-Golf-7-Sw-Alltrack

Replacing a window regulator for Volkswagen Golf 7 Sw Alltrack: how to do it

It takes a long time to change a window regulator. Depending on your experience on the subject, plan approximately three hours to make sure you have the time you need. Whether it's for a Volkswagen Golf 7 Sw Alltrack or another car, this repair is for experienced DIY enthusiasts. So let's take a look at what to do, step by step. It is advisable to take pictures at different times to help you mount the new window regulator.

Removing a window regulator on a Volkswagen Golf 7 Sw Alltrack

  • Remove all of the door trim. From the mirror cover to the handle. Rather, this should be done with care using a flat screwdriver. You will have to make sure you have access to the window regulator at all points without being embarrassed. This step is the longest to perform.
  • Disassemble the window regulator seals from your Volkswagen Golf 7 Sw Alltrack. Again, it is essential to do it delicately.
  • Now that you have accessed the window regulator, remove the connectors. You can then release the motor from the window regulator in the event that it is stuck.
  • Remove all the fasteners that hold the glass, then take it out. It is from time to time advisable to place the window halfway up to perform this operation. Of course, extreme care must be taken when moving the glass. It is advisable to place it on a sufficiently thick sheet.
  • Disassemble the window regulator completely. It is essential to memorize your position. You can take a picture of it if it helps you to install the new window regulator. The window regulator is occasionally held in place by screws or rivets, you must therefore remove them.

The installation of an electric window regulator of a Volkswagen Golf 7 Sw Alltrack

  • Fit the new window regulator. Make sure that its location is similar to the damaged window lifter. You will probably have to use the bindings you have set aside.
  • Replace the glass just as you pulled it out. It will be necessary from time to time to make it move slightly so that it fits correctly in its guide.
  • Reconnect the connectors.
  • Fit the seals you removed.
  • Refit all of the door trim.

It's good, you now have a new and working window regulator . You can therefore switch on the ignition and test it.