Nowadays there are turbos on a lot of cars in circulation, whether it's systems essences ou Diesel. Before starting the DIY it will obviously be necessary to be certain that the concern comes from the turbo of the famous Iveco Massif. However, given that you are reading us now, it shows that you probably know the source.
How to change the turbo of your Iveco Massif
Depending on the turbo to set up, some of the procedures may fluctuate slightly. When you buy a turbocharger it will always be delivered with an assembly note. The ideal is therefore to follow it point by point. On the other hand, in the event that you have not yet made the purchase, here are the steps to follow in order to replace a turbo compressor on your Iveco Massif. In fact you will understand if you have the required skills. Just before starting, make sure you have all of the tools indispensable. You are going to need a bucket for the oil, a bunch of ratchets, pliers, allen and open end wrenches. As a rule, these turbos will be supplied with a set of utensils including joints, studs as well as a dose oil. It is still advisable to have a mechanic checked, since working with a pit remains much easier for this type of work. And of course, the turbocharger is a very sensitive component on the Iveco Massif. Even if the operation is not super complex, we still advise you to go to a mechanic.
- Drain the engine then replace your oil filter. Add a little oil, but not too much. This is an essential manipulation!
- Remove the various plugs present on the turbocharger of the Iveco Massif.
- Check that there are no foreign bodies inside the housings, as this can sometimes be a cause of malfunction.
- Remove the ducts and each of the screws and nuts that hold your turbocharger.
- Remove the existing turbocharger from your Iveco Massif.
- Install the brand new turbocharger, checking that the locations stick precisely
- Replace the oil return pipe
- Replace all the necessary screws and nuts
- Fill the turbocharger with the supplied oil
- Start the turbine by hand to operate the turbocharger.
- Connect the various elements to the turbocharger of the Iveco Massif.
- Once all the components are fitted, you will be able to start the engine and let it run for a few minutes.
Now that everything is in order, but also that the car has been running for about ten minutes, you can take your Iveco Massif for a walk so that you can see that the whole is working well. It is also advisable to check the oil level but also the water regularly in the following weeks. Leave a comment if this tutorial was useful for you. Enjoy again!