Nowadays there are turbos in a large part of the cars on the market, whether in engines essences ou Diesel. Before starting the DIY it is obviously necessary to be convinced that the problem came from the turbo of this Jeep Cj7. That said, since you're on this page, it shows that you probably know the cause.
How to change the turbo on your Jeep Cj7
Depending on the turbo to be presented, the procedures may change very slightly. As soon as you buy a turbo it will be systematically sold with an assembly note. The best is therefore that you read it. However, if you have not made the purchase, here are the steps to follow in order to replace a turbo compressor on the Jeep Cj7. Therefore you will understand what abilities are needed. Just before you start, you must have all the tools required. You will use a bucket for oil, a bunch of ratchet wrenches, flat pliers, allen wrenches as well as flat wrenches. In general, these turbos turn out to be supplied with a batch of utensils which contains joints, studs as well as a dose oil. We still recommend that you have a professional check it simply because working with a pit is more practical for carrying out the work. What is more, the turbo turns out to be a super fragile element in the Jeep Cj7. You should know that handling is not very difficult, it is nevertheless advisable to go to a specialist.
- Drain the engine block and replace your oil filter. Add a little oil, in small quantities. This is an imperative phase!
- Remove all the plugs present at the turbo of this Jeep Cj7.
- Check that there are no undesirable elements in the casings, as this is undoubtedly a source of malfunction.
- Remove the conduits with all the screws but also the nuts which will maintain your turbo.
- Remove the turbo in place in the Jeep Cj7.
- Set up the new turbo, checking that the locations stick perfectly
- Replace the oil return pipe
- Replace the necessary screws and nuts
- Fill the turbo with oil from your syringe
- Operate the turbine by hand so that the turbo turns.
- Connect all of the components to the Jeep Cj7's turbo.
- Now that when the components are found to be installed, you can start the engine block and let it run for a few minutes.
Now that everything is set up and screwed down and of course the car has been running for at least 5 minutes, you need to take a ride in the Jeep Cj7 in order to check that the assembly is working properly. It is advisable at the same time to check the level of oil but also of water quite often for 15 days. Post a comment if our file was useful to you. Enjoy again!