Now we can find turbos on a lot of cars on the market, whether for engines essences ou Diesel. Before you start DIY you will naturally have to be certain that the hassle arises from the turbo of your Jeep Commander. That said, since you are reading this article, it means that you likely know the source.
How to change the turbo of your Jeep Commander
Compared to the turbo to be presented, methods will be able to vary a bit. As soon as you get a turbocharger, the product is always delivered with an assembly note. The best thing to do then is to follow it step by step. However, in the event that you have not yet purchased the product, you will find below an outline for replacing a turbo for your Jeep Commander. In this way you will know if you have the required skills. Just before you start, you must have all of the tools required. You are going to need your bucket for oil, a set of ratchet wrenches, flat pliers, allen wrenches as well as flat wrenches. Very often, turbochargers will be delivered with a lot of utensils which contains joints, studs and a little oil. We still recommend that you have a check done by a pro simply because tinkering with a pit is more practical for this type of manipulation. Furthermore, the turbocharger turns out to be a fairly delicate element in the Jeep Commander. You should know that the operation is not extremely laborious, we still advise you to go to a professional.
- Drain the engine block and replace your oil filter. Replace a small amount of oil. This is a necessary step!
- Remove all the plugs from the Jeep Commander's turbocharger.
- Check that there are no desirable non-elements within the casings, as this is undoubtedly a source of problem.
- Remove the ducts as well as each of the screws and nuts that will hold your turbocharger.
- Remove the existing turbocharger from your Jeep Commander.
- Install the new turbocharger, checking that the locations fully match
- Replace the oil return pipe
- Install each of the screws and nuts you removed
- Fill the turbocharger with the supplied oil
- Operate the turbine with your hands to activate the turbocharger.
- Assemble all the components to the turbocharger of your Jeep Commander.
- Once each of the parts turns out to be installed, you can start the engine block and let it run for 5 to 10 minutes.
Once the assembly is installed but also that the car has been running for a few minutes, you must walk around with your Jeep Commander so as to check that the assembly is working well. We also advise you to check the oil level but also the water level regularly in the weeks that follow. Leave a comment if this file served you. Enjoy again!