Now we can find the turbos on a lot of cars from the last 20 years, whether it's engines essences ou Diesel. Just before starting the DIY it will obviously have to be certain that the hassle comes from the turbo of the famous jeep compass. However, since you have come this far, it means that you probably know the source.change-turbo-jeep-compass

How to change the turbo of your jeep compass

Depending on the turbo to be installed, processes may fluctuate very slightly. When you buy a turbo it will generally be supplied with a manual. It is best to follow it to the letter. Nevertheless in the event that you have not yet made the purchase, you will find below the main lines to replace a turbo compressor on your jeep compass. Therefore you will understand if you have the required skills. Before you start, be careful to have all of the tools required. You are going to use a bucket for engine oil, a bunch of ratchet wrenches, flat pliers, your allen and flat wrenches. Often, these turbos will be sold with their lot of utensils including joints, studs but also a dose oil. However, we recommend that you have a professional check that working from a pit turns out to be even more convenient for these procedures. In addition, the turbo remains a rather fragile element in the jeep compass. You should know that the technique is not frankly laborious, we still advise you to go to a garage.

  • Drain the engine, then replace this oil filter. Put a sprig of oil, without putting too much. This is an inevitable phase!
  • Remove all the plugs from the turbo of your jeep compass.
  • Check that there are no undesirable elements inside the casings, since this is undoubtedly a source of concern.
  • Remove the conduits and all the screws and then the nuts which will allow this turbo to hold.
  • Remove the faulty turbo from the jeep compass.
  • Fit the famous turbo, checking that the joints match precisely
  • Install the oil return pipe
  • Install each of the necessary screws and nuts
  • Fill the turbo with the oil supplied with the turbo
  • Start the turbine with your hands so that the turbo turns.
  • Assemble all the components to the turbo of your jeep compass.
  • Once each of the components are installed, you will be able to start the engine and run it for ten minutes.

Once the assembly is installed and the car has been running for 5 to 10 minutes, you must drive with the jeep compass to see that everything is working properly. It is also advisable to check the oil and water level quite often in the following weeks. Write a comment if our guide was helpful to you. Enjoy again!