Nowadays we find these turbos in most new vehicles, whether in systems essences ou Diesel. Just before embarking on these manipulations you must naturally be convinced that the malfunction comes from the turbo of this Seat 132. That said, since you are reading this article, this means that you probably know the source.change-turbo-Seat-132

How to change the turbo on your Seat 132

Depending on the turbo to be presented, some of the methods may fluctuate slightly. As soon as you buy a turbocharger, it will usually be supplied with an assembly manual. It is best to follow it point by point. On the other hand in the event that you have not yet purchased the product, you will find below the steps to follow to be able to change a turbo compressor on a Seat 132. So you will understand if you have the skills. Before you begin, you must have all of the tools indispensable. You are going to use your oil receptacle, a set of ratchet wrenches, your pliers, allen and flat wrenches. Often, these turbos prove to be supplied with their mounting kit including some jointsFew studs as well as a little oil. However, we advise you to go to a garage because working with a pit is much more convenient to carry out this kind of manipulation. In addition, the turbocharger is a fairly delicate component on a Seat 132. You should know that the operation is not very laborious, we nevertheless advise you to go to a technician.

  • Drain the engine and change your oil filter. Replace a little oil, but very little. This is an inevitable step!
  • Remove all the plugs present on the turbocharger of your Seat 132.
  • Check that there are no undesirable elements inside the casings, because that is undoubtedly a source of concern.
  • Remove the ducts and all of the screws, but also the nuts which hold your turbocharger.
  • Remove the turbocharger in place in your Seat 132.
  • Reassemble the brand new turbocharger, checking that the seals fit perfectly
  • Replace the oil return pipe
  • Fit all the required screws and nuts
  • Fill the turbocharger with the oil supplied with the turbo
  • Rotate the turbine manually to rotate the turbocharger.
  • Attach all the components to the turbocharger of this Seat 132.
  • Once all the parts are installed, you can start the engine and let it run for ten minutes.

Now that the turbo is in place but also that the engine has been running for a few minutes, you must walk around in your Seat 132 to check that the assembly works well. We also advise you to check the oil and water level often enough for 15 days. Leave a comment if ever this tutorial was useful. Enjoy the road!