Nowadays there are turbos in most cars of the last 20 years, as many on engines essences ou Diesel. Just before you start DIY, you must of course be sure that the malfunction comes from the turbo of your Toyota Dyna. That said, since you've come this far, it means you probably know the source.
How to change the turbo of your Toyota Dyna
Depending on the turbo to be installed, the procedures may vary a little. As soon as you get a turbocharger, the product will generally be supplied together with an instruction manual. The best thing to do is therefore to read it. However, in case you have not yet made the purchase, here are the main lines to be able to replace a turbo compressor on the Toyota Dyna. Thereafter you will understand what abilities are needed. Before starting, you must have all of the tools required. You will use a bucket for oil, a set of ratchet wrenches, flat pliers, allen wrenches as well as flat. Often these turbos turn out to be supplied with their tool kit which contains joints, studs but also a dose oil. We still advise you to go to a mechanic because working with a pit turns out to be even more convenient for handling. What is more, the turbocharger remains a very delicate element on this Toyota Dyna. You should know that the handling is not downright difficult, it is nevertheless advisable to go to a garage.
- Drain the engine and replace this oil filter. Add a small amount of oil. This is an imperative procedure!
- Remove all the plugs from the Toyota Dyna turbocharger.
- Check that there are no desirable non-elements inside the casings, since this is sometimes a source of malfunction.
- Remove the ducts and all the screws as well as the nuts which hold this turbocharger.
- Remove the faulty turbocharger from your Toyota Dyna.
- Reassemble the new turbocharger, checking that the seals stick completely
- Install the oil return pipe
- Replace all the screws and nuts you removed
- Fill the turbocharger using the oil supplied
- Manually rotate the turbine to operate the turbocharger.
- Connect all components to the Toyota Dyna turbocharger.
- Once all the parts are assembled, you can start the engine and let it run for 5 to 10 minutes.
Now that everything is installed and screwed, but also that the engine has been running for at least 5 minutes, you can drive with your Toyota Dyna to check that the assembly works properly. It is also advisable to watch the oil level but also the water level quite often in the weeks that follow. Post a comment in case this tutorial was useful. Enjoy again!