Nowadays you can find these turbos in most automobiles of the past 20 years, whether in engines essences ou Diesel. Before starting these manipulations it is obviously necessary to be sure that the hassle comes from the turbo of this Toyota Ft-86 (2). That said, if you are on this page, you probably know the source.
How to change the turbo on your Toyota Ft-86 (2)
Depending on the turbo to be installed, the manipulations may vary very slightly. When you buy a turbocharger, it will always be supplied with an assembly note. The best thing to do is therefore to follow it point by point. That said, in case you have not purchased the product, you will find below the steps to follow in order to replace a turbo for the Toyota Ft-86 (2). In this way you will know if you have the required skills. Before you start, you must have all the tools adequate. You will need an oil bucket, a set of ratchet wrenches, your pliers, allen and flat wrenches. Often, turbochargers are found to be sold with a tool kit that includes joints, studs and a dose oil. It is still advisable to go to a mechanic since tinkering with a pit is even easier to do the manipulations. In addition, the turbocharger happens to be a rather sensitive element in a Toyota Ft-86 (2). Even if the operation is not really difficult, it is nevertheless advisable to go to a technician.
- Drain the engine block then replace your oil filter. Put a sprig of oil, without putting too much. This is a necessary phase!
- Remove all the plugs from the turbocharger of your Toyota Ft-86 (2).
- Examine that there are no desirable undesirable elements in the casings, because this is a source of concern.
- Remove the ducts with all of the screws and the nuts that will hold your turbocharger.
- Remove the existing turbocharger from your Toyota Ft-86 (2).
- Set up the famous turbocharger, checking that the seals match completely
- Replace the oil return pipe
- Install all required screws and nuts
- Fill the turbocharger with the supplied oil
- Start the turbine manually to turn the turbocharger.
- Reattach all of the components to the turbocharger of your Toyota Ft-86 (2).
- Once all of the components are installed, you can start the engine block and operate it for 5 to 10 minutes.
Once everything is installed and screwed but also that the car has been running for some time, you can drive in your Toyota Ft-86 (2) to verify that everything is working properly. At the same time, we advise you to check the oil and water level fairly frequently in the following weeks. Post a comment in the event that our file has been useful to you. Good road !