Nowadays we find the turbos in a large part of the automobiles on the market, as much on systems essences ou Diesel. Before starting the DIY it is of course necessary to be sure that the problem comes from the turbo of the famous Toyota Ft-86. Having said that, since you are reading this article, it means you probably know the reason for it.
How to change the turbo of your Toyota Ft-86
Compared to the turbo to be positioned, the methods will be able to vary very slightly. As soon as you buy a turbo the product will always be supplied with an instruction manual. The ideal is therefore that you read it. On the other hand, in the event that you have not yet made the purchase, you will find below the operations to be done to be able to change a turbo compressor in a Toyota Ft-86. In fact you will understand if you have the skills. Just before starting, make sure you have all of the tools required. You will need a container for the oil, a set of ratchets, flat pliers, allen and flat wrenches. Usually, these turbos are supplied with a mounting kit that includes joints, studs but also a syringe oil. We still suggest that you go see a mechanic because working from a pit remains much more practical for this work. And of course the turbo is an extremely fragile component on a Toyota Ft-86. Even if the operation is not particularly difficult, it is nevertheless advisable to go to a technician.
- Change the engine block oil then change this oil filter. Add a little oil, in a small quantity. It is a necessary step!
- Remove all the plugs found around the turbo of this Toyota Ft-86.
- Check that there are no undesirable elements inside the housings, since this is sometimes a source of concern.
- Remove the ducts as well as all the screws and nuts which will support this turbo.
- Remove the faulty turbo from the Toyota Ft-86.
- Set up the famous turbo by checking that the locations are completely sticking
- Install the oil return pipe
- Replace all the required screws and nuts
- Fill the turbo with oil from your syringe
- Manually start the turbine to activate the turbo.
- Reattach all the connections to the turbo of this Toyota Ft-86.
- Now that when all the components are installed, you can start the engine block and run it for about ten minutes.
Once the assembly is installed and the engine has been running for at least 5 minutes, you can drive the Toyota Ft-86 to check that the assembly works well. We also recommend that you check the oil and water level quite often in the coming days. Write a comment if this guide was helpful. Good walk !