Nowadays we find the turbos in most automobiles of the last 20 years, as many on engines essences ou Diesel. Before starting work, you must of course be sure that the problem comes from the turbo of this Toyota Hi Ace. However if you are reading us it means you most likely know the cause.
How to change the turbo of your Toyota Hi Ace
Depending on the turbo to position, some of the handling may change very slightly. When you buy a turbo it is always sold with an assembly note. It is therefore best that you follow it to the letter. But in case you have not yet purchased the product, below is the outline for replacing a turbo compressor in the Toyota Hi Ace. This will help you understand if you have the required skills. Just before you start, you must have all the tools adequate. You will need your receptacle for the engine oil, a set of ratchets, flat pliers, allen wrenches as well as flat keys. Usually, turbochargers will be supplied with their tool kit which contains a few jointsFew studs and a syringe oil. It is still advisable to go to a professional since working with a pit is even easier to do the procedures. Also, the turbo happens to be a super fragile component on this Toyota Hi Ace. Taking into account that the operation is not very complex, we still advise you to go to a technician.
- Drain the engine block and replace the oil filter. Add a little oil, but not too much. This is an imperative phase!
- Remove all the plugs present on the turbo of your Toyota Hi Ace.
- Examine that no residue is found within the crankcases, as this is undoubtedly a source of concern.
- Remove the conduits and of course all the screws and the nuts that will maintain the turbo.
- Remove the existing turbo from your Toyota Hi Ace.
- Install the new turbo, checking that the seals are completely suitable
- Fit the oil return pipe
- Fit all the screws and nuts that you removed
- Fill the turbo using the oil supplied with the turbo
- Start the turbine with your hands so that the turbo turns.
- Assemble all the components to the turbo of your Toyota Hi Ace.
- Once all the components are assembled, you must start the engine block and run it for about ten minutes.
Now that everything is installed and screwed in and the car has been running for a few minutes, it is necessary to walk around in your Toyota Hi Ace to check that the assembly is working properly. We also recommend that you check the oil and water level quite frequently in the following weeks. Leave a comment if this file has been useful to you. Good road !