Nowadays there are turbos on a lot of new cars, whether for engines essences ou Diesel. Before you get started, you will obviously have to be convinced that the problem comes from the turbo of the famous Toyota Prius 3. But since you are on this page, this means that you probably know the cause.
How to change the turbo of your Toyota Prius 3
Compared to the turbo to be implemented, methods may fluctuate slightly. When you buy a turbo it usually comes with an Achievement Note. The best thing to do is to follow it to the letter. However if you never made the purchase, here are the main axes to be able to replace a turbo compressor on your Toyota Prius 3. Therefore you will understand if you have the required skills. Just before you start, you must have all of the tools adequate. You will use your bucket for oil, a bunch of ratchet wrenches, your pliers, your allen and flat wrenches. Usually turbochargers come with a lot of utensils including joints, studs but also a dose oil. However, we recommend that you have a specialist check that tinkering with a pit is easier for these manipulations. In addition, the turbo is a very sensitive element for the Toyota Prius 3. Even if the technique is not extremely difficult, we still advise you to go to a mechanic.
- Drain the engine block and replace your oil filter. Replace a little oil, without putting too much. This is an imperative step!
- Remove all the plugs found on the turbo of the Toyota Prius 3.
- Check that there are no residues in the crankcases, as this can be a cause for concern.
- Remove the conduits as well as all of the screws and then the nuts that will hold your turbo.
- Remove the existing turbo from this Toyota Prius 3.
- Fit the all-new turbo, checking that the seals are completely suitable
- Install the oil return pipe
- Reassemble each of the required screws and nuts
- Fill the turbo with oil from your syringe
- Operate the turbine by hand so that the turbo turns.
- Assemble all the turbo connections of your Toyota Prius 3.
- As soon as each of the components are installed, you will be able to start the engine block and let it run for 5 to 10 minutes.
Once the assembly is installed and of course that the car has been running for ten minutes, it is necessary to walk around behind the wheel of this Toyota Prius 3 in order to verify that everything is working properly. We also advise you to check the oil and water level fairly frequently in the coming days. Post a comment in case our text helped you. Enjoy again!