Before you start, you need to understand a few things about the pilot lights, also known as low beam. Unlike some lights, they are mandatory. They must be at least two and work on the left as on the right. They must also light up to 30 meters without blinding motorists vis-à-vis. In the event that one of the lights on the Willys Jeep is broken, you risk a ticket of 68 euros. Naturally, it is above all for safety reasons that it is necessary to replace them when they no longer work. We will now see how to replace these low beams on the Jeep Willys, step by step.change-light-low-beam-Jeep-Willys

How to Change a Night Light on a Willys Jeep

Before starting operations, it is essential to stop the engine. Allow approximately 5 or 10 minutes for this change of low beam on a Jeep Willys. This operation does not require a specific tool, except a flat screwdriver to help you if a cover is difficult to come.

  • Open the hood of the Willys Jeep
  • Identify the location of the lighthouse block
  • Remove the protective cover so as to gain access to the light unit
  • Disconnect the connector
  • Carefully remove the bulb from the low beam
  • Compare the new bulb with the old one to be sure it is totally suitable
  • Gently put the new bulb in its place. Make sure it is fixed and properly engaged
  • Replace the connector, but also the cover

Its good. Changing a low beam on a Willys Jeep is an extremely simple and fast operation, accessible to beginners. See you soon!