First of all, you will need to understand several information about the pilot lights, also called dipped beam. Unlike some lights, they are mandatory. They must be at least two and work on the left as on the right. They must also light up to 30 meters without dazzling the conductors opposite. If one of the lights of the Seat 128 does not work, you risk a ticket of 68 euros. Of course, it is first of all for safety reasons that it is necessary to change them when they no longer work. Now let's see how to change these low beams on the Seat 128, point by point.change-light-low-beam-Seat-128

How to change a pilot on a Seat 128

Before starting the manipulations, it is necessary to switch off the engine. Allow approximately 5 or 10 minutes for this replacement of the low beam on the Seat 128. This manipulation does not require any specific tool, except perhaps a flat screwdriver to help you if a cover has trouble removing.

  • Open the hood of the Seat 128
  • Locate the location of the headlight unit
  • Remove the protective cover so as to reach the light unit
  • Disconnect the connector
  • Carefully remove the bulb from the low beam
  • Compare the new bulb with the old one to be sure it is fully suitable
  • Place the new bulb gently in its location. Make sure it is fixed and properly engaged
  • Replace the connector, but also the cover

Its good. Replacing a low beam on the Seat 128 is an extremely simple and quick repair, accessible to beginners. See you soon!