Before you start, you need to know various indications about the pilot lights, the technical term of which is low beam. Unlike some lights, they are mandatory. They must be at least two and operate on the left and on the right. They must also light up to 30 meters without blinding the conductors opposite. Assumed that one of the lights of the Toyota Camry 3 does not work, you will risk a fine of 68 euros. Of course, it is primarily for safety reasons that it is essential to replace them when they no longer work. We will now see how to replace these low beam on the Toyota Camry 3, point by point.
How to Change a Night Light on a Toyota Camry 3
Before starting operations, it is essential to stop the engine. Allow approximately 5 or 10 minutes for this change of low beam on a Toyota Camry 3. This repair does not require any special tool, except perhaps a flat screwdriver to help you if a cover is difficult to remove.
- Open the hood of the Toyota Camry 3
- Identify the location of the lighthouse block
- Remove the protective cover so as to reach the light unit
- Disconnect the connector
- Gently remove the bulb from the low beam
- Compare the new bulb with the old one to be sure it is totally suitable
- Gently place the new bulb in its location. Check that it is stable and well engaged
- Put the connector in its place, but also the cover
That's it. Changing a low beam on a Toyota Camry 3 is an extremely easy and short operation, accessible to beginners. Good road!