Before you start, you need to understand some information about the pilot lights, also called low beam. Unlike some lights, they are mandatory. They must be at least two and walk left and right. They must also light up to 30 meters without blinding the conductors opposite. In the event that one of the lights of the Toyota Ft-86 (2) is broken, you risk a ticket of 68 euros. Of course, it is above all for safety reasons that it is essential to change them when they no longer work. We will now see how to change these low beam on the Toyota Ft-86 (2), step by step.
How to change a pilot light on a Toyota Ft-86 (2)
Before starting operations, it is necessary to switch off the engine. Allow approximately 5 or 10 minutes for this replacement low beam on the Toyota Ft-86 (2). This manipulation does not require a specific tool, except maybe a flat screwdriver to help you if a cover is difficult to remove.
- Open the hood of the Toyota Ft-86 (2)
- Locate the location of the headlight unit
- Remove the protective cover in order to access the light unit
- Disconnect the connector
- Gently remove the bulb from the low beam
- Compare the new bulb with the old one to be sure it fits completely
- Carefully place the new bulb in its location. Make sure it is fixed and properly engaged
- Replace the connector, but also the cover
It is done. Changing a low beam on the Toyota Ft-86 (2) is an extremely easy and fast operation, accessible to any level in the field. Good walk!