Before starting, you should know some indications about the pilot lights, the technical term of which is dipped beam. Unlike some lights, these are mandatory. They must be at least two and work on the left as well as on the right. They must also illuminate at a distance of 30 meters without blinding motorists in front. Supposing that one of the lights on your Toyota Land Cruiser Serie 40 is broken, you risk a fine of 68 euros. Of course, it is primarily for safety reasons that it is essential to replace them when they no longer work. Let's see now how to replace these low beams on the Toyota Land Cruiser Serie 40, point by point.change-light-low-beam-Toyota-Land-Cruiser-Serie-40

How to change a night light on a Toyota Land Cruiser Serie 40

Before starting operations, it is essential to switch off the engine. Allow approximately 5 or 10 minutes for this low beam replacement on a Toyota Land Cruiser Serie 40. This manipulation does not require any specific tool, except perhaps a flat screwdriver to help you if a cover struggles to remove. .

  • Open the hood of the Toyota Land Cruiser Serie 40
  • Identify the location of the headlight unit
  • Remove the protective cover so as to gain access to the light unit
  • Disconnect the connector
  • Carefully remove the bulb from the low beam
  • Compare the new bulb with the previous one to be sure it fits completely
  • Carefully put the new bulb in its place. Watch that it is stable and correctly engaged
  • Replace the connector, but also the cover

That's it. Replacing a low beam on a Toyota Land Cruiser Serie 40 is an extremely easy and short repair, accessible to any level in the field. Be careful!