Before starting, you should understand several indications about the pilot lights, the technical term of which is low beam. Unlike some lights, these are essential. They must be at least two and work on the left as well as on the right. They must also illuminate at a distance of 30 meters without dazzling the users opposite. If one of the lights on your Toyota Land Cruiser Sw Serie 60 does not work, you could risk a fine of 68 euros. Of course, it is first of all for safety reasons that it is essential to replace them when they no longer work. We will now see how to replace these low beams on the Toyota Land Cruiser Sw Serie 60, point by point.
How to change a pilot light on a Toyota Land Cruiser Sw Serie 60
Before starting operations, it is essential to turn off the engine. Allow approximately 5 or 10 minutes for this change of low beam on the Toyota Land Cruiser Sw Serie 60. This repair does not require any specific tool, except perhaps a flat screwdriver to help you if a cover has trouble. to come up.
- Open the hood of the Toyota Land Cruiser Sw Serie 60
- Identify the location of the lighthouse block
- Remove the protective cover in order to reach the fire block
- Disconnect the connector
- Carefully remove the bulb from the low beam
- Compare the new bulb with the old one to be sure it fits perfectly
- Carefully put the new bulb in its place. Check that it is fixed and properly engaged
- Put the connector in its place, but also the cover
That's it. Replacing a low beam on the Toyota Land Cruiser Sw Serie 60 is an extremely simple and short repair, accessible to beginners. Good walk!