Before starting, you should know various indications about the pilot lights, also called dipped beam headlamps. Unlike some lights, these are essential. They must be at least two and operate on the left as well as on the right. They must also illuminate at a distance of 30 meters without blinding users in front. If one of the lights of the Toyota Mr 2 is not functional, you risk a fine of 68 euros. Of course, it is firstly for safety reasons that it is essential to change them when they no longer work. Let's see now how to change these low beam headlights on the Toyota Mr 2, step by step.
How to change a pilot light on a Toyota Mr 2
Before starting operations, it is necessary to turn off the engine. Allow approximately 5 or 10 minutes for this low beam replacement on a Toyota Mr 2. This manipulation does not require any special tool, except a flat screwdriver to help you if a cover struggles to remove.
- Open the hood of the Toyota Mr 2
- Locate the location of the headlight unit
- Remove the protective cover in order to reach the fire block
- Disconnect the connector
- Gently remove the bulb from the low beam
- Compare the new bulb with the old one to be sure it fully matches
- Carefully put the new bulb in its place. Check that it is fixed and properly engaged
- Put the connector in its place, but also the cover
Its good. Replacing a low beam on a Toyota Mr 2 is an extremely easy and short repair, accessible to beginners. Good road!