First of all, you will need to know some information about sidelights, also called low beam headlights. Unlike some lights, these are essential. They must be at least two and operate on the left as well as on the right. They must also illuminate at 30 meters without blinding the motorists opposite. Supposing one of the lights on the Jeep Wagoneer is broken, you will risk a fine of 68 euros. Naturally, it is initially for safety reasons that it is essential to replace them when they no longer work. We will now see how to replace these low beams on the Jeep Wagoneer, step by step.change-crossing-light-Jeep-Wagoneer

How to change a night light on a Jeep Wagoneer

Before starting the manipulations, it is necessary to switch off the engine. Allow approximately 5 or 10 minutes for this change of low beam on a Jeep Wagoneer. This operation does not require any particular tool, except a flat screwdriver to help you if a cover is struggling to come.

  • Open the hood of the Jeep Wagoneer
  • Locate the location of the headlight unit
  • Remove the protective cover so as to reach the fire block
  • Disconnect the connector
  • Gently remove the bulb from the low beam
  • Compare the new bulb with the old one to be sure it fits completely
  • Carefully put the new bulb in its place. Check that it is fixed and properly engaged
  • Replace the connector and the cover

Its good. Replacing a low beam on a Jeep Wagoneer is a very easy and short repair, accessible to any level in the field. Enjoy the road!