When the clock runs out of light, it can be unpleasant. So you have to change the display bulb of this Toyota Prius. Even if the dashboard is still functional, we are missing several indications to drive in good conditions. This operation is not complex to perform, but requires a minimum of rigor. We advise you to take photos at different stages to remember the reverse process, especially regarding connectors. To perform this task, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers is enough. Now let's take a look at how to change this bulb, point by point.
How to change the bulb on the Toyota Prius display
Depending on the release dates, the procedure may vary slightly. It is conceivable that some covers or screws differ. Here is therefore the logic to be followed in general.
- Start with remove the covers of the facade which hinder accessibility to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to take off some screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, it will disconnect connectors which connect to the clock bulb of this Toyota Prius. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if it can be useful to you.
- Normally you can access the defective bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be similar in terms of base and volume. The tension as well obviously.
- Put in the new bulb by checking that it is at the bottom of its location.
- Replace the connectors as they were.
- Replace all of the front covers.
You can leave us a comment if you have encountered specific concerns.