That it concerns low beam, high beams or turn signals, the changing a light bulb is a very repair simple to execute . But if ever a fire does not work any more, one should not delay to replace it. Because some people do not know it, but this remains punishable by a sanction of up to 68 euros. Obviously, it will first be necessary to change them for safety reasons. So here is how to change the bulb of a headlight on the Seat Tribu, point by point. Second, we will find out how to properly adjust them.change-headlight-bulb-Seat-Tribu

How to change the bulb of a Seat Tribu headlight

Today, there are a number of types of headlight bulbs. The most common are halogen , however there are also Xenon , a little put on the side today, and a lot of bulbs LED . These consume less energy and are more resistant. Regardless of the type of bulb, the way to change them will be the same. So this is the logic to follow for change the bulb of your Seat Tribu .

  • Disconnect the battery so that you can work more serenely.
  • Free access to the rear part of the light. It will sometimes be necessary to remove the battery, or covers.
  • Remove the rubber or plastic cover behind the fire
  • Unclip or unscrew the defective bulb from your Seat Tribu
  • Compare it with the new one to be sure it fits
  • Place the new bulb gently, then fix it correctly
  • Replace the rubber cover and all the elements in the other direction

Once everything is in place, check that it works! The latter should have the same intensity as the other. It is essential to have perfectly similar products.

Setting up the headlights of a Seat Tribu correctly

After replacing a light, it is still possible that it will be out of order. It is very important that two lights at the same height and focused in the same way. Notably so as not to annoy motorists in front. You must therefore take the time to adjust them correctly. To do this, you have to position your car facing a wall. At first a short distance, then a few meters. Second, it suffices to adjust the light with the new bulb at the same height as the other by comparing the halos. If both are incorrectly set, there are tutorials that can help you.