Replace the light bulb of a Seat Ibe ceiling light is an extremely repair easy to perform . No need to be a great mechanic, it requires few tools and no mechanical knowledge. To do this, count about 10 minutes . However before you start the work, you will have to make sure that the problem comes from the bulb. We will see first how to find out where the problem comes from, then how to replace the burnt out bulb.change-bulb-ceiling-lamp-Seat-Ibe

The ceiling lighting of your Seat Ibe does not work anymore: the different reasons.

The bulb is defective . This is of course the most common cause. Whatever happens, you will have to dismantle the lighting unit of your Seat Ibe. In order to do this, you will need to follow the steps in the next paragraph. To control it is extremely easy. If ever it is a filament bulb, you can visually check that the filament is broken. If on the other hand it is an LED bulb, you will have to check that the electricity is flowing correctly thanks to a voltmeter. Remember to measure the voltage on the two poles of the connector. An electrical problem . It's less ordinary, however it can still happen on a Seat Ibe. There may be a short juice, or a connector may be dirty. In this case, examine the voltage at the two poles. If the electricity does not pass correctly, you will have to follow the wiring until you find the cause of the failure. The connectors may also be dirty. Then, you will have to clean them with a specialized product and measure the tension again.

How to replace the light bulb on your Seat Ibe

Now that you have found the cause of the failure, you are sure that the problem is with the bulb. We will see how to replace the ceiling light bulb step by step on a Seat Ibe.

  • Remove the ceiling light using a flat screwdriver. Insert it into the groove to pry.
  • Remove the connector
  • Disassemble the ceiling light so as to have access to the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must be identical
  • Carefully place the new bulb
  • Replace the connectors and the dome following the reverse procedure

You can now switch on the ignition and check that the bulb works properly. It's good, voila! The bulb of the ceiling lamp of your Seat Ibe should work normally. Good road.