Replace the light bulb in a seat leon is a super manipulation simple to execute . No need to be a great mechanic, this requires basic tools and no knowledge of mechanics. To carry out this replacement, plan ten minutes . But before you start repairing, you will have to make sure that the problem comes from the bulb. We will first see how to find out where the problem came from, then how to change the burnt out bulb.change-bulb-ceiling-lamp-seat-leon

The lighting of the ceiling light of your seat leon does not work anymore: the different reasons.

The bulb is defective . This is of course the most common cause. Whatever happens, you're going to have to remove the light block from the seat leon. To do this, you will have to follow the steps in the following paragraph. To control it it's super simple. When it is a filament bulb, you can visually check that its filament is broken. When, on the other hand, it is an LED bulb, you will have to check that the current flows correctly using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical problem . It's less ordinary, but it can still happen on a seat leon. There may be a short juice, or a connector may be dirty. In this case, inspect the voltage at both poles. When the current does not flow correctly, the electric cables must be followed until the source of the fault is perceived. The connectors may also be dirty. So, you will have to clean them with a specialized product and measure the voltage again.

How to replace the light bulb in your seat leon

Now that you have found the source of the failure, you are sure that the problem originated from the bulb. We will see how to change the bulb of the ceiling light step by step on a seat leon.

  • Remove the ceiling light with a flat screwdriver. Insert it into the groove to pry.
  • Remove the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Naturally, the dimensions and the base must be identical
  • Place the new bulb gently
  • Replace the connectors and the dome following the reverse procedure

You can now turn on the ignition and check that the bulb is working properly. And now, voila ! The light bulb in your seat leon should work normally. Enjoy the road.