Replacing the light bulb in a Nissan Laurel is a very operation simple to make . No need to be an excellent handyman, it requires few tools and no mechanical knowledge. To carry out this operation, plan about 10 minutes . However before you start the work, you will have to make sure that the problem comes from the bulb. We will see first how to know where the problem originated, then how to change the burnt out bulb.change-bulb-ceiling-light-Nissan-Laurel

The ceiling bulb of your Nissan Laurel does not work anymore: the different causes.

The bulb is defective . This is of course the most common cause. Whatever happens, you will have to dismantle the lighting unit of your Nissan Laurel. To do this, you will have to follow the steps in the following paragraph. To verify it is very simple. In case it is a filament bulb, you can visually check that this filament is broken. In the case where on the other hand it is an LED bulb, it will be necessary to check that the electricity circulates properly using a voltmeter. Remember to measure the voltage on both sides of the connector. An electrical concern . It is less common, however it can still happen on this Nissan Laurel. It happens that there is a short-juice, or that a connector is dirty. In this situation, examine the voltage at the two poles. In the event that the electricity does not pass properly, you will have to follow the wiring until you find the source of the failure. It also happens that the connectors are dirty. In this case, you will have to clean them with a specialized product and measure the tension.

How to replace the light bulb on your Nissan Laurel

Now that you have found the cause of the failure, you are certain that the problem came from the bulb. We will see how to change the bulb of the ceiling light point by point on this Nissan Laurel.

  • Remove the ceiling lamp using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it with the new one. It is of course necessary that the dimensions and the base correspond
  • Attach the new bulb gently
  • Replace the connectors and the ceiling light in the opposite direction

You can now turn on the ignition and check that the bulb is working properly. It's good, voila! The ceiling lamp of your Nissan Laurel should work normally. Good walk.