Replacing the headlight bulb of a Seat Tango is a super repair easy to execute . There is no need to be a great mechanic, this repair requires basic tools and no knowledge of mechanics. To perform this operation, plan about 10 minutes . However, before starting the work, it is necessary to make sure that the problem must come from the bulb. We will first find out how to know where the problem must come from, then how to change the burnt out bulb.change-bulb-ceiling-lamp-Seat-Tango

The ceiling bulb of your Seat Tango has stopped working: various reasons.

The bulb is defective . This is of course the most common reason. Whatever happens, you will need to remove the light unit from your Seat Tango. To do this, it is necessary to follow the steps in the next part. To check it is super easy. If it's a filament bulb, you can visually check that that filament is broken. If, on the other hand, it is an LED bulb, it is necessary to check that the current flows properly thanks to a voltmeter. Try to take the voltage on the two connector poles. An electrical concern . It's less frequent, but it can still happen on this Seat Tango. It happens that there is a short juice, or a connector is dirty. In this situation, check the voltage at both poles. If the current does not flow properly, you must follow the wiring until you see the source of the fault. It also happens that the connectors are dirty. In this case, it will be necessary to clean them using a specialized product and measure the tension again.

How to replace the ceiling bulb of your Seat Tango

Once you have found the cause of the failure, you are certain that the problem must come from the bulb. We will see how to change the bulb of the ceiling light point by point on this Seat Tango.

  • Remove the ceiling light using a flat screwdriver. Pass it in the groove to make a lever.
  • Disconnect the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. Of course, the size and the base must match
  • Attach the new bulb carefully
  • Reposition the connectors and the ceiling light in the other direction

You can now turn on the ignition and check that the bulb is working properly. It's good it's done ! The ceiling bulb of your Seat Tango should work normally. Good road.