When the clock stops lighting up, it can get annoying. So you have to replace the display bulb of the jeep grand cherokee. Even if the dashboard remains operational, we are missing several information to circulate in good conditions. This manipulation is not complex to perform, but requires a minimum of rigor. We advise you to take pictures at certain stages to remind you of the reverse manipulation, especially for the connectors. To accomplish this task, plan approximately a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's see how to replace this bulb, point by point.
How to change the jeep grand cherokee display bulb
Depending on the release dates, the method may vary a little. Some covers or screws may not be the same. We therefore suggest the general procedure to follow.
- Start with remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove several screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of your jeep grand cherokee. You will be able to remove all the connectors from the unit, provided you remember the location. Help yourself by taking pictures if needed.
- Normally you can have access to the broken bulb. Gently dismantle the bulb of the clock.
- Compare the new bulb with the previous one. This must be identical in terms of base and volume. The tension as well obviously.
- Put in the new bulb making sure it is at the bottom of its socket.
- Put the connectors in place as they were.
- Put all the covers on the front.
You can leave us a comment if you have encountered specific concerns.