When the clock has no more light, it can be annoying. So you have to change the display bulb of the Seat Ateca. Even if the dashboard is still operational, we lack certain information to drive in sufficient comfort. This action is not hard to perform, but requires a minimum of thoroughness. We also advise you to take photos at different stages to remember the reverse manipulation, especially for the connectors. To perform this task, allow about a small half-hour . For tools, a set of screwdrivers will suffice. Now let's see how to change this bulb, point by point.change-bulb-clock-Seat-Ateca

How to change the bulb on the Seat Ateca display

Depending on the release year, the procedure may vary a little. It remains likely that some covers or screws differ. So here is the logic to follow in general.

  • Start with remove the covers of the facade which hinder accessibility to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. In this situation, keep them carefully aside.
  • Once the facade has been completely removed, you must disconnect connectors which connect to the clock bulb of this Seat Ateca. You will be able to remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if necessary.
  • You can normally have access to the broken bulb. Carefully remove the bulb of the clock.
  • Compare the new bulb with the old one. This must be identical in terms of base and volume. The voltage also naturally.
  • Put in the new bulb by checking that it is at the bottom of its location.
  • Replace the connectors in their location.
  • Replace all of the front covers.

Do not hesitate to leave a comment if you have encountered particular problems.