When the clock stops working, it can be annoying. We will therefore have to replace the display bulb of this Smart Crosstown. Although the dashboard remains operational, we are missing certain information in order to circulate in good conditions. This action is not complex to perform, but requires a minimum of thoroughness. We advise you to take pictures at certain stages in order to remind you of the reverse manipulation, especially concerning the connectors. To perform this operation, count approximately a small half-hour . In terms of tools, a pair of screwdrivers should suffice. Now let's see how to change this bulb, point by point.
How to change the Smart Crosstown display bulb
Depending on the years of circulation, the method may vary slightly. It is conceivable that a few covers or screws differ. This is therefore the logic to be followed in general.
- Start with remove the covers of the front panel which impede access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove some screws. In this case, keep them carefully aside.
- Once the facade has been completely removed, you must disconnect connectors that connect to the clock bulb of this Smart Crosstown. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking pictures if that can be helpful.
- Normally you can have access to the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The voltage as well of course.
- Place the new bulb by checking that it is at the bottom of its location.
- Replace the connectors in their location.
- Replace all of the front covers.
Do not hesitate to leave a comment if you have encountered particular concerns.