When the clock stops working, it can be annoying. It will therefore be necessary to replace the display bulb of this Volkswagen 1302. Even if the dashboard remains functional, it lacks certain information in order to circulate in sufficient comfort. This manipulation is not hard to perform, but requires a minimum of rigor. We also advise you to take photos at certain stages in order to remind you of the reverse manipulation, particularly concerning connectors. To carry out this manipulation, plan about a small half-hour . For tools, a set of screwdrivers should suffice. Now let's see how to change this bulb, step by step.
How to change the bulb on the Volkswagen 1302 display
Depending on the release dates, the methodology may vary a little. It is possible that some covers or screws are not identical. This is therefore the procedure to be followed in general.
- Start with remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. In this situation, keep them preciously aside.
- Once the front is completely removed, you need disconnect connectors connected to the clock bulb of this Volkswagen 1302. You will be able to disassemble all the connectors of the block, provided you remember the location. Help yourself with your camera if needed.
- Normally you can have access to the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. This should be similar in terms of base and volume. The voltage also naturally.
- Put in the new bulb making sure it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
We invite you to leave us a comment if you have encountered specific malfunctions.