When the clock runs out of light, it can get annoying. So you have to replace the display bulb of this Opel Movano 2. Although the dashboard is still operational, we are missing several pieces of information in order to drive comfortably. This manipulation is not hard to perform, but requires a minimum of thoroughness. It is also advisable to take photos at certain stages in order to remember the reverse process, especially for connectors. To perform this task, allow about a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's see how to replace this bulb, step by step.
How to change the bulb on the display of the Opel Movano 2
Depending on the release dates, the procedure may vary a little. Some covers or screws may not be the same. So that's the general approach to follow.
- Start by remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. In this situation, keep them preciously aside.
- Once the facade has been completely dismantled, disconnect connectors connected to the clock bulb of the Opel Movano 2. You will be able to remove all the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- Normally you can access the defective bulb. Gently remove the bulb of the clock.
- Compare the new bulb with the old one. This must be identical in terms of base and volume. The voltage also of course.
- Place the new bulb by checking that it is located at the bottom of its socket.
- Replace the connectors as they were.
- Replace all of the front covers.
You can leave us a comment if you have encountered any particular problems.