When the clock stops lighting up, it can be annoying. So you have to replace the display bulb of this Opel Omega 2. Even if the dashboard remains functional, we are missing certain information in order to circulate in good conditions. This operation is not complex to perform, but requires a minimum of rigor. It is also advisable to take photos at certain stages in order to remind you of the opposite approach, particularly concerning connectors. To perform this task, plan approximately a small half-hour . In terms of tools, a pair of screwdrivers will suffice. Now let's see how to replace this bulb, point by point.
How to change the bulb on the display of the Opel Omega 2
Depending on the release dates, the methodology may vary slightly. It is conceivable that some covers or screws differ. So that's the logic to follow in general.
- Start by remove the covers of the front panel which obstruct access to the display. You can use a flat screwdriver to pry into the grooves. You may need to remove a few screws. In this situation, keep them preciously aside.
- Once the facade has been completely dismantled, disconnect connectors which connect to the clock bulb of your Opel Omega 2. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself by taking photos if necessary.
- You can normally have access to the damaged bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the old one. This should be similar in terms of base and volume. The voltage also naturally.
- Place the new bulb by checking that it is at the bottom of its location.
- Put the connectors in place.
- Put all the covers on the front.
Do not hesitate to leave us a comment if you have encountered particular problems.