When the clock runs out of light, it can be unpleasant. So we will have to change the display bulb of the Opel Rekord. Although the dashboard remains operational, it lacks several indications to circulate in good conditions. This operation is not complex to perform, but requires a minimum of thoroughness. It is indeed advisable to take photos at certain stages to remind you of the opposite approach, especially concerning connectors. To carry out this manipulation, plan approximately a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's take a look at how to replace this bulb step by step.
How to change the light bulb on the Opel Rekord display
Depending on the years of circulation, the methodology may vary slightly. It is likely that several covers or screws are not identical. This is the logic to follow in general.
- Start by remove the covers of the front panel which prevent access to the display. You can use a flat screwdriver to pry in the grooves. It happens that you have to remove several screws. Therefore, keep them carefully aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of the Opel Rekord. You can therefore dismantle all of the block's connectors, provided that you remember the location. Help yourself by taking photos if it can be useful to you.
- You can normally access the defective bulb. Carefully remove the bulb of the clock.
- Compare the new bulb with the previous one. This must be identical in terms of base and volume. The voltage also naturally.
- Place the new bulb making sure it is at the bottom of its location.
- Replace the connectors as they were.
- Replace all of the front covers.
You can leave a comment if you have encountered any particular concerns.