When the clock stops working, it can get annoying. So you have to change the display bulb of the Opel Senator. Even if the dashboard remains functional, we are missing certain indications to drive in sufficient comfort. This action is not hard to perform, but requires a minimum of thoroughness. We also advise you to take photos at different stages to remind you of the opposite approach, especially for connectors. To carry out this manipulation, count approximately a small half-hour . In terms of tools, a set of screwdrivers should suffice. Now let's see how to change this bulb, step by step.
How to change the bulb on the Opel Senator display
Depending on the release dates, the method may vary slightly. It remains likely that several covers or screws differ. Here is therefore the logic to be followed in general.
- Start by remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove a few screws. In this situation, keep them preciously aside.
- Once the facade has been completely removed, disconnect connectors which connect to the clock bulb of this Opel Senator. You can therefore dismantle all of the block's connectors, provided you remember the location. Help yourself with your camera if it helps you.
- Normally you can have access to the damaged bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the old one. The latter should be similar in terms of base and volume. The voltage also of course.
- Put in the new bulb by checking that it is at the bottom of its location.
- Replace the connectors as they were.
- Replace all of the front covers.
Do not hesitate to leave us a comment if you have encountered particular problems.