When the clock stops working, it can get annoying. So we will have to change the display bulb of the Smart Crossblade. Although the dashboard remains functional, we are missing certain indications in order to drive comfortably. This action is not difficult to perform, but requires a minimum of thoroughness. We also advise you to take photos at certain stages in order to remember the reverse manipulation, especially regarding connectors. To accomplish this task, count roughly a small half-hour . For tools, a set of screwdrivers is sufficient. Now let's see how to replace this bulb, point by point.
How to change the bulb on the Smart Crossblade display
Depending on the release dates, the methodology may vary a little. It is possible that some covers or screws are not identical. Here is the procedure to follow in general.
- Start with remove the covers of the front panel which prevent accessibility to the display. You can use a flat screwdriver to pry in the grooves. You may need to remove more than one screw. In this case, keep them carefully aside.
- Once the facade has been completely removed, disconnect connectors connected to the Smart Crossblade clock bulb. You can therefore remove all the connectors from the block, provided you remember the location. Help yourself with your camera if needed.
- You can normally have access to the broken bulb. Carefully disassemble the bulb of the clock.
- Compare the new bulb with the previous one. The latter must be similar in terms of base and volume. The voltage also obviously.
- Put in the new bulb by checking that it is at the bottom of its location.
- Replace the connectors in their location.
- Replace all of the front covers.
Please do not hesitate to leave us a comment if you have encountered specific concerns.