Replacing the light bulb of a jeep wrangler is a very operation easy to execute . No need to be an excellent handyman, it requires few tools and no mechanical knowledge. To carry out this operation, plan about 10 minutes . But before starting the work, it is necessary to make sure that the problem comes from the bulb. We will see at first how to know where the problem comes from, then how to replace the damaged bulb.change-bulb-ceiling-jeep-wrangler

The bulb of the ceiling light of your jeep wrangler does not work anymore: the different causes.

The bulb is defective . This is of course the most common reason. Whatever happens, you will have to disassemble the light unit from your jeep wrangler. To do this, it is necessary to follow the steps in the following paragraph. To control it is very easy. If it is a filament bulb, you can visually check that its filament is broken. If, on the other hand, it is an LED bulb, it is necessary to check that the electricity is flowing correctly thanks to a voltmeter. Try to take the voltage on both sides of the connector. An electrical concern . It is less common, however it can still happen on a jeep wrangler. There may be a false contact, or a connector may be dirty. In this situation, examine the voltage at the two poles. If the electricity does not pass correctly, you will have to follow the electric wires until you find the cause of the failure. The connectors may also be dirty. So, we will have to clean them using a specialized product and measure the voltage.

How to replace the light bulb in your jeep wrangler

Once you have found the cause of the failure, you are certain that the problem comes from the bulb. Let's see how to replace the light bulb point by point on a jeep wrangler.

  • Remove the ceiling light with a flat screwdriver. Pass it in the groove to leverage.
  • Remove the connector
  • Dismount the ceiling light so as to access the bulb
  • Remove the bulb and compare it to the new one. It is of course necessary that the size and the base are identical
  • Attach the new bulb carefully
  • Replace the connectors and the ceiling light in the other direction

You can now turn on the ignition and check that the bulb is working properly. It's good, voila! The light bulb in your jeep wrangler should work normally. Enjoy the road.