Using working flashing lights remains a legal requirement. Think about it, not putting a turn signal is punishable by 3 point on the permit as well as a fine . Although some law enforcement officials are sometimes sympathetic on this point. It therefore remains essential to have flashing lights in good condition. We will find out with this article how to change the bulb of a turn signal for a Hyundai Ix35, front and rear. It is also conceivable that the malfunction comes from a short circuit, however it remains quite exceptional.change-flashing-Hyundai-Ix35

Hyundai Ix35: things to know before changing your turn signal

Firstly, it is important to choose the correct bulb model! So as not to be mistaken, we advise you to go to a spare parts site or to your car repairer who can select them. Then you have to think about choosing the right color for your bulb. Finally, you will need a tools super simple but still essential. You will therefore need a screwdriver for a Hyundai Ix35. A cruciform and torx kit and nothing can happen to you. Most of the time, the bulbs are at bayonet . To dismantle the damaged bulb, it will be necessary to turn the bulb a quarter of a turn anticlockwise. So as to put the new bulb, it is necessary to rotate a quarter of a turn in the opposite direction.

How to change the bulb of a front indicator on a Hyundai Ix35

There are two main ways to access the flashing lights. It depends on the models, however accessibility can be done either outside or inside on this Hyundai Ix35. Access from inside the engine : First of all, you will have to open the hood. Then, you will need to remove the cover with a screwdriver (usually a torx) in order to access the light block. When the block is unscrewed, remove it and it is possible to change the bulb. Wheel arch access : Look below the wheel to see if the clips are there. If this is the case, the fixings must be undone and the screws removed using a screwdriver. Then remove the light unit from your Hyundai Ix35 slowly from the front. You simply need to change the bulb and position the block in the opposite direction. Exceptionally, on certain cars it is conceivable to remove the block of lights from the outside. But it is quite rare. If this is the case, with a screwdriver you will have to remove the fixings, gently remove the light block and change the faulty bulb.

How to change the bulb of a rear indicator on a Hyundai Ix35

There are also two main ways to access your turn signal bulb. It can depend on the different types, however accessibility can be done either from inside or outside. Access from inside the trunk : Generally accessibility can be done inside the trunk. For these headlight blocks, you will find screws and fixings. Take them out and remove the block, being careful. Finally, you will simply have to replace the faulty bulb with a new one. Then repeat this operation in the other direction. It is also conceivable that accessibility can be from the outside or through the wheel arch. But it is much rarer. Whatever happens, you must use your screwdriver and carefully remove the entire headlight unit in order to change this bulb. To reassemble, proceed to the opposite step.