Using flashing lights that work remains mandatory. As a reminder, not putting a flashing light is punishable by 3 point on the permit as well as a fine . Even if some police officers are sympathetic at times on this point. It is therefore essential to have flashing lights that work properly. We will see in this article how to replace the bulb of a turn signal for a Hyundai Pony, front and rear. It is also conceivable that the problem comes from a short circuit, but it remains rather rare.
Hyundai Pony: things to know before replacing your turn signal
To start it is essential to properly buy the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts website or to a car repairer who knows how to select them. In the second step, you will have to think about choosing the right color for your bulb. Finally, you will need a tools extremely simple but nevertheless essential. You will therefore need a screwdriver for a Hyundai Pony. A cruciform and torx game and nothing can happen to you. Generally, the bulbs are at bayonet . In order to dismantle the defective bulb you will have to rotate it by a quarter of a turn anticlockwise. In order to install the new bulb, it is necessary to rotate it a quarter of a turn in the opposite direction.
How to change the bulb of a front indicator on a Hyundai Pony
There are two main ways to get to the turn signals. Indeed, it depends on the models, but accessibility can be done either from the outside or from the inside on this Hyundai Pony. Access from inside the engine : First, you have to open your hood. Then, it will be necessary to remove a cover with the help of a screwdriver (generally torx) in order to access the headlight unit. Once the unit is unclipped, remove it and do not hesitate to replace this bulb. Wheel arch access : Inspect below the wheel to see if the clips are there. In case this is happening, you have to undo the hooks and remove the screws using a screwdriver. Then remove the headlight unit from this Hyundai Pony gently from the front. You simply need to replace the bulb and reattach the light block the other way. Exceptionally, on some models it is conceivable to remove the headlight unit from the outside. However, it is rather rare. In the event that this is happening, with the help of a screwdriver you will need to remove the fasteners, remove the headlight unit slowly and change the failed bulb.
How to change the bulb of a rear indicator on a Hyundai Pony
There are also two main ways to access your turn signal bulb. It can depend on the ranges, however accessibility can be done either from the inside or from the outside. Access from inside the trunk : Frequently accessibility can be done from inside the trunk. For these headlight blocks, there are screws and fasteners. Remove them and gently lay the block down. Finally, you will simply have to replace this faulty bulb with a new one. Then repeat this operation in reverse. It is also conceivable that accessibility can be from the outside or under the wheel arch. However, it is much rarer. In all cases, you must take your screwdriver and remove, paying attention to the entire block of lights so as to replace the bulb. To reassemble, perform the reverse manipulation.