Having turn signals that are in good condition is a legal requirement. Remember, forgetting to put a turn signal is punishable by 3 point on the permit as well as a fine . Even if certain agents of the law are at times benevolent on this subject. It is therefore essential to have the turn signals in good working order. We will see in this article how to replace the bulb of an indicator light on an Iveco Massif, front and rear. It is also likely that the problem arose from a short circuit, but it is quite rare.change-flashing-Iveco-Massif

Iveco Massif: things to know before replacing your turn signal

First of all, it is essential to buy the correct bulb model! In order not to make a mistake, we advise you to go to a spare parts website or to a mechanic who knows how to order them for you. Then you will have to think about selecting the right color for your bulb. Subsequently, you will need to use a tools super simple but still essential. You will therefore mainly need a screwdriver for an Iveco Massif. A cruciform and torx game and nothing can happen to you. Most of the time, the bulbs are at bayonet . In order to take out the faulty bulb, you will have to turn it a quarter of a turn to the left. In order to fit the new bulb, it will therefore be necessary to rotate it a quarter of a turn in the other direction.

How to change the bulb of a front indicator on an Iveco Massif

There are two different ways to get to the turn signals. It depends on the model, but access can be done either from the outside or from the inside for your Iveco Massif. Access from inside the engine : To begin with, you will have to open the hood. Then you need to loosen a cover with the help of a screwdriver (usually torx) to access the light assembly. When the block is unclipped, remove it and do not hesitate to replace the bulb. Wheel arch access : Inspect under the wheel to see if the clips are in this location. When this is what happens, you will have to remove the hooks and remove the screws using a screwdriver. Then remove the light block of this Iveco Massif slowly from the front. All you need to do is replace the bulb and put the light unit back in the other direction. Exceptionally, for some models it is likely to remove the light unit from the outside. But it is quite rare. When this is what happens, with the help of a screwdriver you will have to remove the fixings, remove the light unit quietly and change the faulty bulb.

How to change the bulb of a rear indicator on an Iveco Massif

There are also two different ways to access this turn signal bulb. It depends on the ranges but access can be done either from the inside or from the outside. Access from inside the trunk : Almost every time access can be done from inside the safe. Regarding the headlight blocks, you will find screws and fixings. Remove them and remove the block being careful. Then you simply have to change the faulty bulb with the new one. Then repeat this operation in reverse order. It is also likely that the access could be from the outside or through the wheel arch. But it is much rarer. In all cases, you will have to use your screwdrivers and take care to remove the entire headlamp assembly so as to replace your bulb. To reassemble it, perform the opposite operation.