Having flashing lights that are in good condition remains an obligation of the law. As a reminder, not putting a flashing light is punishable by 3 point on the permit as well as a traffic ticket . Even if certain police officers are sympathetic at times on this subject. It therefore remains necessary to have flashing lights in good condition. We will see below how to replace the bulb of a flashing light from Iveco Minicab, front and rear. It is also possible that the malfunction comes from a false contact, however it is relatively exceptional.
Iveco Minicab: things to know before replacing your turn signal
Above all, it is wiser to choose the right type of bulb! So as not to be mistaken, we advise you to go to a spare parts site or to your car repairer who can order them for you. In the second time it will be necessary to think of selecting the right color of the bulb. Then you will need to use a tools super simple but nonetheless essential. You will therefore need a screwdriver for an Iveco Minicab. A kit of cruciform and torx and you will necessarily be able to get there. Generally, the bulbs are at bayonet . To dismantle the damaged bulb, it must be turned a quarter of a turn anti-clockwise. In order to fix the new bulb, you will therefore have to turn a quarter of a turn in the other direction.
How to change the bulb of a front indicator on an Iveco Minicab
There are two different ways to access the flashing lights. It depends on the different models, however accessibility can be done either outside or inside for an Iveco Minicab. Access from inside the engine : To start, you have to open the hood. Then, it will be necessary to loosen a cover with the help of a screwdriver (usually torx) in order to access the headlight unit. Now that the block is unscrewed, remove it and you can replace the bulb. Wheel arch access : Check below the wheel to see if the fasteners are there. If this is the case, you will have to disassemble the fasteners and remove the screws with the help of your screwdriver. In the second step, carefully remove the headlight assembly from your Iveco Minicab from the front. You just need to replace the bulb and replace the light block following the reverse procedure. Exceptionally, for some models it is still possible to replace the headlight unit from the outside. But it is relatively rare. If this is the case, with the help of a screwdriver, you will have to remove the fixings, gently remove the headlight unit and replace the faulty bulb.
How to change the bulb of a rear indicator on an Iveco Minicab
There are also two different ways to access this turn signal bulb. It depends on the range, however accessibility can be done either from inside or outside. Access from inside the trunk : In most of the cases the accessibility can be done inside the trunk. At the level of the light blocks, there are screws and fixings. Take them out and put the piece down, being careful. Then you just have to replace the faulty bulb with a new one. Then repeat the same manipulation in the other direction. It also remains possible that accessibility is from the outside or through the wheel arch. But it is much rarer. Whatever happens, you will need to bring your screwdrivers and carefully remove the entire light unit to replace this bulb. To reassemble, perform the opposite manipulation.