It is a legal obligation to use turn signals that work. Think about it, not putting on a flashing light is punishable by 3 point on the permit as well as a traffic ticket . Even if some police officers are at times benevolent on this point. It is therefore essential to have turn signals in good working order. We will therefore discover in this article how to replace the bulb of a turn signal on an Iveco Minivan, front and rear. It is also conceivable that the malfunction comes from a short circuit, however this is still quite exceptional.
Iveco Minivan: things to know before replacing your indicator
First of all, it is essential to properly buy the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts site or to your mechanic who will be able to select them. Secondly, you will have to be careful to select the right color for the bulb. Then you will need to use a tools extremely simple but nevertheless necessary. You will therefore need a screwdriver for an Iveco Minivan. A set of cruciforms and torxes and everything will be doable. In the majority of cases, the bulbs are bayonet . In order to remove the defective bulb, it will be necessary to turn the latter a quarter of a turn counterclockwise. To install the new bulb, you must then turn it a quarter of a turn in the other direction.
How to change the bulb of a front indicator on an Iveco Minivan
There are two main ways to access the flashing lights. Indeed, it depends on the different models, however accessibility can be done either from the outside or from the inside for your Iveco Minivan. Access from inside the engine : First of all, you have to open your hood. And then, it will be necessary to unscrew the cover with the help of a screwdriver (often torx) in order to access the light unit. As soon as the block is unclipped, remove it and your bulb can be replaced. Wheel arch access : Look below the wheel to see if the clips are there. If this is the case, you must disassemble the fasteners and remove the screws with the help of your screwdriver. In the second place remove the headlight block of this Iveco Minivan gently from the front. You simply need to replace the bulb and reattach the block by following the reverse procedure. More rarely, for some cars it is still conceivable to remove the light unit from the outside. However, it is quite rare. If this is the case, with the help of a screwdriver you will have to remove the fixings, release the headlamp unit slowly and change the defective bulb.
How to change the bulb of a rear indicator on an Iveco Minivan
There are also two main ways to access your turn signal bulb. It depends on the ranges, however accessibility can be done either from inside or outside. Access from inside the trunk : In most cases, accessibility can be done from the trunk. For these headlight blocks there are screws and fixings. Remove them and remove the part gently. Then you just have to change your defective bulb with a new one. And then repeat the same manipulation in the opposite direction. It is further conceivable that accessibility could be from the outside or through the wheel arch. However, it is much rarer. In all cases, you must have your screwdriver and gently remove the entire light unit in order to replace this bulb. To set it up, do the opposite.