Having working flashing lights is mandatory. As a reminder, not putting a flashing light is liable to 3 point on your driver's license as well as a traffic ticket . Although some police officers are occasionally complacent on this point. It therefore remains essential to have flashing lights that work properly. So we will see below how to change the bulb of a flashing light of a Jeep Comanche, front and rear. It is also conceivable that the concern comes from a short circuit, however this remains quite rare.change-flashing-Jeep-Comanche

Jeep Comanche: things to know before changing your turn signal

To start it is important to correctly select the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts website or to an auto repairer who can select them. In the second step, you must be careful to choose the right color for the bulb. Finally, you will need a tools very basic but still essential. You will therefore need a screwdriver for a Jeep Comanche. A kit of cruciform and torx and you will necessarily be able to get there. In most cases, the bulbs are at bayonet . In order to remove the faulty bulb, you must turn the bulb a quarter of a turn to the left. To install the new bulb, you will have to turn it a quarter of a turn in the opposite direction.

How to change the bulb of a front indicator on a Jeep Comanche

There are two different ways to access the indicators. It depends on the models, however accessibility can be done either outside or inside for this Jeep Comanche. Access from inside the engine : First of all, you will have to open your hood. And then, you will need to remove a cover with a screwdriver (frequently torx) in order to access the headlight unit. When the unit is unclipped, remove it and do not hesitate to change the bulb. Wheel arch access : Check below the wheel to see if the fasteners are there. If this ever happens, you will have to undo the fasteners and remove the screws with a screwdriver. Then remove the headlight unit from this Jeep Comanche gently from the front. All you have to do is change the bulb and position the block in the other direction. More rarely, for some models it is conceivable to remove the headlight unit from the outside. However it is quite rare. If this is what happens, with a screwdriver you will have to disassemble the fixings, remove the headlight unit quietly and change the burnt out bulb.

How to change the bulb of a rear indicator on a Jeep Comanche

There are also two different ways to access the turn signal bulb. It can depend on the ranges but accessibility can be done either from the inside or from the outside. Access from inside the trunk : Most of the time accessibility can be done from inside the trunk. At the headlight blocks, there are screws and fasteners. Remove them and remove the part slowly. To finish it will simply be necessary to change the bulb burned out by the new one. And then repeat the same manipulation in the other direction. It also remains conceivable that accessibility can be from the outside or under the wheel arch. However, it is much less frequent. In all cases, you will need to use your screwdriver and carefully remove the entire block of lights so as to change your bulb. To put it in place, perform the reverse manipulation.