Using working indicators is mandatory. Think about it, omitting a flashing light is punishable by 3 point on the permit as well as a fine . Even if certain law officers are regularly sympathetic on this point. It therefore remains essential to have indicators in good condition. We will therefore see with this article how to change the bulb of a turn signal for a Jeep Renegade, front and rear. It is also conceivable that the malfunction comes from a false contact, however this remains relatively exceptional.
Jeep Renegade: things to know before changing your turn signal
At first it is wiser to choose the model of your bulb! In order not to be mistaken, we advise you to go to a spare parts site or to your garage which will be able to select them. In a second step you will have to think about choosing the right color for your bulb. Thereafter, you will need to use a tools super simple but nevertheless essential. You will therefore need a screwdriver for a Jeep Renegade. A game of cruciform and torx and everything will be doable. Most of the time, the bulbs are at bayonet . In order to dismantle the broken bulb, you will have to rotate the bulb a quarter turn to the left. To fix the new bulb, you will have to rotate it a quarter of a turn in the other direction.
How to change the bulb of a front indicator on a Jeep Renegade
There are two main ways to get to the turn signals. It depends on the models, however access can be done either from the outside or from the inside for a Jeep Renegade. Access from inside the engine : At first, you will need to open your hood. Then, you must loosen the cover using a screwdriver (often torx) to access the light block. When the block is unscrewed, remove it and it is possible to change your bulb. Wheel arch access : Inspect underneath the wheel to see if the clips are there. In case this is happening, you will have to undo the hooks and remove the screws using a screwdriver. Then remove the light block from the Jeep Renegade delicately from the front. It is now enough to change your bulb and reattach the block in the opposite direction. Less frequently, for some cars it is conceivable to replace the block of lights from the outside. However, it is relatively rare. In the event that this is happening, using a screwdriver you will need to remove the fixings, gently remove the light block and change your burnt out bulb.
How to change the bulb of a rear indicator on a Jeep Renegade
There are also two main ways to access your turn signal bulb. It can depend on the ranges but the access can be done either inside or outside. Access from inside the trunk : Generally access can be done from the trunk. Regarding the light units, there are screws and fixings. Take them out and remove the block, being careful. Then you just have to replace your burnt out bulb with a new one. Then repeat the same manipulation in reverse. It also remains conceivable that access is from the outside or under the wheel arch. However, it is much less frequent. In all cases, you will need to use your screwdriver and gently remove the entire light block in order to change the bulb. To reassemble, take the opposite step.