Having turn signals that are in good condition is mandatory. Remember, forgetting to put a turn signal is punishable by 3 point on the permit as well as a traffic ticket . Although some police are sometimes lenient on this point. It is therefore essential to have indicators in good condition. So we'll see below how to replace the bulb of a turn signal for a Kia Stinger, front and rear. It is sometimes conceivable that the malfunction comes from a short circuit, however it is relatively rare.change-flashing-Kia-Stinger

Kia Stinger: things to know before replacing your turn signal

To begin with it is wiser to select the correct bulb model! So as not to be mistaken, we advise you to go to a spare parts site or to your car repairer who knows how to order them for you. Then you will have to think about selecting the right color for your bulb. Thereafter, you will need a tools super basic but still necessary. You will therefore need a screwdriver for a Kia Stinger. A cruciform and torx kit and nothing can happen to you. Almost every time, the bulbs are bayonet . In order to dismantle the broken bulb you will have to turn it a quarter of a turn to the left. In order to fix the new bulb, it is therefore necessary to turn a quarter of a turn in the other direction.

How to change the bulb of a front indicator on a Kia Stinger

There are two different ways to access the indicators. Indeed, it depends on the different models, however access can be done either from the outside or from the inside for this Kia Stinger. Access from inside the engine : First of all, you will have to open the hood. And then, it is necessary to remove the cover using a screwdriver (regularly torx) to access the block of lights. As soon as the block is unscrewed, remove it and it is possible to replace this bulb. Wheel arch access : Inspect below the wheel to see if the fasteners are there. When this is correct, it is necessary to disassemble the fixings and remove the screws with a screwdriver. Then remove the light block from the Kia Stinger slowly from the front. All you have to do is replace the bulb and reattach the block in reverse. Exceptionally, for some models it is conceivable to replace the block of lights from the outside. But it is relatively rare. When it is well that, using a screwdriver you will have to remove the fixings, remove the block of lights slowly and change the defective bulb.

How to change the bulb of a rear indicator on a Kia Stinger

There are also two different ways to access the turn signal bulb. It depends on the models, however access can be done either from the inside or from the outside. Access from inside the trunk : In most of the cases the access can be done from the trunk. At the level of the light blocks, there are screws and fixings. Take them out and put the piece down, being careful. Thereafter it is necessary to only change this faulty bulb with a new one. And then repeat this operation in the other direction. It is also conceivable that access can be from the outside or under the undertray. But it is much less frequent. Whatever happens, it is necessary to bring your screwdrivers and remove, being careful, the entire headlight unit in order to replace this bulb. To reassemble, do the opposite.