Using flashing lights that are in good condition is mandatory. Think about it, forgetting to put a turn signal is punishable by 3 point on the permit as well as a fine . Although some police officers are sometimes lenient on this point. It is therefore essential to have flashing lights that work correctly. We will therefore see with this article how to replace the bulb of a Kiaage 2 indicator light, front and rear. It is sometimes conceivable that the problem stems from a poor contact, but it is relatively rare.change-flashing-Kiaage-2

Kiaage 2: things to know before replacing your indicator

To begin with, it is important to correctly purchase the type of bulb! In order not to be mistaken, we advise you to go to a spare parts site or to a mechanic who will know how to select them. Secondly, you have to be careful to choose the right color for the bulb. Finally, you will need a tools super simple but nevertheless essential. So you will mainly need a screwdriver for a Kiaage 2. A cruciform and torx kit and everything will be doable. Usually the bulbs are bayonet . To remove the defective bulb you will need to rotate the bulb a quarter of a turn counterclockwise. In order to put the new bulb, it is necessary to rotate it a quarter of a turn in the opposite direction.

How to change the bulb of a front indicator on a Kiaage 2

There are two main ways to access the turn signals. It depends on the different models, but access can be done either from the outside or from the inside for this Kiaage 2. Access from inside the engine : First, you will need to open your hood. And then you have to remove a cover with the help of a screwdriver (frequently torx) to access the light assembly. Now that the block is unscrewed, remove it and the bulb can be replaced. Wheel arch access : Check below the wheel to see if the clips are in this location. When that's it, you have to undo the hooks and remove the screws using a screwdriver. Secondly, remove the headlamp assembly of this Kiaage 2 slowly from the front. Now all you have to do is replace the bulb and put the light unit back in the opposite direction. Exceptionally, for some models it is still conceivable to remove the light unit from the outside. However, it is relatively rare. When it is correct, with the help of a screwdriver it will be necessary to remove the fasteners, release the headlamp unit slowly and change the burnt bulb.

How to change the bulb of a rear indicator on a Kiaage 2

There are also two main ways to access this indicator bulb. It depends on the ranges, however access can be done either from the inside or from the outside. Access from inside the trunk : Almost every time access can be done from inside the boot. For these light blocks there are screws and fasteners. Remove them and pull the block out slowly. Finally you only have to replace the burnt out bulb with a new one. And then redo this operation in the other direction. It is also conceivable that the access can be from the outside or under the wheel arch. However, it is much rarer. Whatever happens, you must use your screwdrivers and gently remove the entire headlight assembly in order to replace your bulb. To set it up, do the opposite.