Using working flashing lights is mandatory. Remember, not putting a flashing light is punishable by 3 point on your driver's license as well as a traffic ticket . Although some police officers are sometimes sympathetic on this point. It is thus essential to have flashing lights that work properly. We will see in this article how to change the bulb of a indicator of a Seat 128, front and rear. It is also conceivable that the problem comes from a short circuit, but it is relatively rare.change-flashing-Seat-128

Seat 128: things to know before changing your turn signal

First of all it is essential to properly select your type of bulb! In order not to be mistaken, we advise you to go to a spare parts website or to your garage which can order them for you. In a second step you must think about choosing the right color for your bulb. Thereafter, you will need to use a tools very simple but still essential. You will therefore mainly need a screwdriver for a Seat 128. A cruciform and torx kit and you can necessarily do this. In most cases, the bulbs are at bayonet . In order to dismantle the defective bulb, you will have to rotate it by a quarter of a turn to the left. In order to install the new bulb, it is necessary to rotate a quarter of a turn in the opposite direction.

How to change the bulb of a front indicator on a Seat 128

There are two main solutions to get to the flashing lights. It depends on the models, but access will be either from the outside or from the inside on a Seat 128. Access from inside the engine : Initially, it will be necessary to open the hood. And then, you must remove the cover with a screwdriver (usually torx) to access the light block. When the block is unscrewed, remove it and do not hesitate to change the bulb. Wheel arch access : Inspect the wheel below to see if the fasteners are there. If this is happening, remove the hooks and remove the screws using a screwdriver. Then remove the light block of this Seat 128 carefully from the front. All you have to do is change your bulb and put the light block back in the opposite direction. Exceptionally, on certain cars it is conceivable to remove the block of lights from the outside. However, it is relatively rare. If this is what is happening, with a screwdriver you will have to remove the fixings, gently release the light block and change your faulty bulb.

How to change the bulb of a rear indicator on a Seat 128

There are also two main solutions for accessing this turn signal bulb. It depends on the different types, however access will be either from the inside or from the outside. Access from inside the trunk : Frequently access will be from inside the trunk. For these light blocks, you will find screws and fixings. Remove them and remove the part slowly. Thereafter it is only necessary to change the defective bulb by the new one. And then repeat this operation in reverse. It is also conceivable that access can be from the outside or through the wheel arch. However, it is much rarer. Whatever happens, you must bring your screwdrivers and gently remove the entire block of lights in order to change the bulb. To set it up, take the opposite approach.